Finally managed to get my BMW Advanced Eye 2.0 working again
My first one went pop after 3 years, looks like a common issue, image goes all dark with lines across. Anyway, found a replacement on eBay used. Received it in the post, slid it into my existing screen mounted shoe still stuck to the screen with the existing wiring but it still has the previous owners setup in it so need to factory reset. Searched everywhere, no clear instructions anywhere. Figured it out in the end myself.
Update the firmware and the wifi settings will reset.
Turn the unit off
Remove SD card (32GB)
Format in your laptop as Fat32
Download the firmware file straight to the root of the newly formatted SD card. Here
Power on the unit without the SD until she asks for it!
Insert SD and wait a moment, unit will reboot itself
Green and red LEDs will flash for up to 7 minutes. Do not touch, be patient. Power down will turn it into junk
When the lights stop, give it a minute
Connect using the default wifi app on your phone to the BMWACE2.0 wifi and 1234567890 as the key
Open the Ace app
It will prompt you to change the defaults here, I just add a zero to the end of the current key
Then you can get into the Ace app and perform a factory reset at the bottom of the configure page
Job done
http://www.advancedcareye.com/FW/
Lots of people slate the BMW one but all dash cams are fundamentally flawed by a simple wet windscreen so say what you will.
Cheers Ladies
Hope this helps someone
Daren